Replacing The Srx5400 Services Gateway Air Filter; Removing The Srx5400 Services Gateway Air Filter - Juniper SRX5400 Hardware Manual

NOTE: Air filters will not be replaced by Juniper Networks under the Juniper Networks
Hardware Replacement Support Plan, you need to purchase them for replacement.
CAUTION:
operating. Because the fans are very powerful, they could pull small bits of wire
or other materials into the services gateway through the unfiltered air intake. This
could damage the services gateway components.
The shelf life of polyurethane filter varies from two years to five years depending on the storage
conditions. Store in a cool, dry, and dark environment. Wrap the media in plastic and store in an
environment with relative humidity between 40%- 80% and temperature between 40°F (4° C) to 90°F
(32° C). Note that if the material flakes, or becomes brittle when rubbed or deformed, it is no longer
usable.

Replacing the SRX5400 Services Gateway Air Filter

To replace the air filter, perform the following procedures in sequence:

Removing the SRX5400 Services Gateway Air Filter | 230

1.
Installing the SRX5400 Services Gateway Air Filter | 231
2.
Removing the SRX5400 Services Gateway Air Filter
CAUTION:
air filter in place.
CAUTION:
during replacement. Because the fans are very powerful, they could pull small bits of
wire or other materials into the device through the unfiltered air intake. This could
damage the services gateway components.
To remove the air filter (see
Always keep the air filter in place while the services gateway is
Do not run the services gateway for more than a few minutes without the
Always keep the air filter in place while the device is operating, except
Figure 97 on page 231):
230