Replacing The Srx5400 Services Gateway Air Filter; Removing The Srx5400 Services Gateway Air Filter - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
Related
Documentation

Replacing the SRX5400 Services Gateway Air Filter

Removing the SRX5400 Services Gateway Air Filter

110
Grasp the fan tray handle and insert it straight into the chassis. Note the correct
2.
orientation by the
this side up
Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
3.
Figure 39: Installing the Fan Tray
Removing the Fan Tray Before Installing an SRX5400 Services Gateway Without a Lift
on page 213
Reinstalling the Fan Tray After Installing the SRX5400 Services Gateway Without a
Lift on page 219
Maintaining the Fan Tray on the SRX5400 Services Gateway on page 82
To replace the air filter, perform the following procedures in sequence:
Removing the SRX5400 Services Gateway Air Filter on page 110
1.
Installing the SRX5400 Services Gateway Air Filter on page 111
2.
CAUTION: Do not run the services gateway for more than a few minutes
without the air filter in place.
CAUTION: Always keep the air filter in place while the device is operating,
except during replacement. Because the fans are very powerful, they could
label on the top surface of the fan tray.
Copyright © 2014, Juniper Networks, Inc.