Connect To A Network For Out-Of-Band Management; Connect A Management Console; Connect The Ioc Cables - Juniper SRX 5600 Getting Started Manual

Figure 8: Connect External Devices and IOC Cables

Connect to a Network for Out-of-Band Management

1.
2.
3.

Connect a Management Console

1.
2.
3.

Connect the IOC Cables

1.
2.
WARNING: Do not look directly into a fiber-optic transceiver or into the ends of
fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a
transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when inserting
or removing cable. The safety cap keeps the port clean and prevents accidental
exposure to laser light.
Turn off the power to the management device.
Plug one end of the RJ-45 Ethernet cable into the appropriate
the Routing Engine.
Plug the other end of the cable into the network device.
Turn off the power to the management device.
Plug RJ-45 end of the serial cable into the appropriate
the Routing Engine.
Plug the female DB-9 end into the device's serial port.
Have ready a length of the type of cable used by the IOC. For cable specifications,
see the SRX 5600 Services Gateway Hardware Guide.
If the IOC cable connector port is covered by a rubber safety plug, remove the
plug.
Step 4: Connect External Devices and IOC Cables
CONSOLE
Step 4: Connect External Devices and IOC Cables
port on
ETHERNET
or port on
AUX
13