Static Multicast Forwarding; Static Multicast Forwarding Overview; What You Can Do; What You Need To Know - ZyXEL Communications XMG1915 Series User Manual

Static Multicast Forwarding

40.1 Static Multicast Forwarding Overview

This chapter discusses how to configure static multicast forwarding rules based on multicast MAC
addresses or multicast IPv4 addresses.
Use these screens to configure static multicast address forwarding by defining the ports and VLANs that
multicast traffic can pass through the Switch. If a subscriber is on a different port or VLAN, then the
subscriber will not get the multicast.

40.1.1 What You Can Do

Use the Static Multicast Forwarding By MAC screen
forward specific multicast frames, such as streaming or control frames, to specific ports.

40.1.2 What You Need To Know

A multicast MAC address or multicast IP address is the MAC address or IP address of a multicast group,
and not a receiving device.
A static multicast address is a multicast MAC address or multicast IPv4 address that has been manually
entered in the multicast table. This identifies the destination of the multicast content. Multicast IPv4
addresses uses the Class D IP addresses range 224.0.0.0 to 239.255.255.255. Multicast MAC addresses
have a "1" as the last binary bit of the first octet pair (for example, 01:00:5e:00:00:0A). Static multicast
addresses do not age out. See
addresses.
Note: Static (manual) multicast forwarding allows you (the administrator) to forward multicast
frames to a member without the member having to join the group first.
If a multicast group has no members, then the Switch cannot forward to specific ports unless you
configure static (manual) multicast entries. The Switch will either flood the multicast frames to all ports
(default) or drop them.
ports. With static multicast forwarding, you can forward these multicasts to ports within a VLAN group.
Chapter 40 Static Multicast Forwarding
IP Multicast Addresses on page 222
Figure 160 on page 229 shows such unknown multicast frames flooded to all
XMG1915 Series User's Guide
228
C
H A P T E R
(Section 40.2 on page 229) to configure rules to
for more information on IP multicast
40