Restrictions By The Serial No. And Version - Mitsubishi Electric QD77MS User Manual

2.5 Restrictions by the SERIAL No. and version

Function
Inverter FR-A700 series
Driver communication function
Synchronous encoder via servo
amplifier
Mark detection function
(Changes latch data range upper
limit value/lower limit value during
mark detection.)
External command signal
compensation valid/invalid setting
Operation cycle setting for
QD77MS2/QD77MS4
Servo driver (VCII series)
manufactured by Nikki Denso Co.,
Ltd. (SSCNET /H)
Servo driver (VPH series)
manufactured by Nikki Denso Co.,
Ltd.
MR-JE-B
Hot line forced stop function
AlphaStep/5-phase stepping motor
driver manufactured by ORIENTAL
MOTOR Co., Ltd. (SSCNET /H)
IAI electric actuator controller
manufactured by IAI Corporation
(SSCNET /H)
Optional data monitor function data
type
Internal temperature of encoder,
Module power consumption (Used
point: 2 words)
(Note-1): The serial number can be checked on the "Product Information List" screen in GX Works2.
(Note-2): "MELSEC-Q/L QD77MS/QD77GF/LD77MS/LD77MH Simple Motion Module User's Manual (Synchronous Control)"
There are restrictions in the function that can be used by the SERIAL No. of the Simple
Motion module and the version of GX Works2.
The combination of each version and function is shown below.
QD77MS2/QD77MS4
First five digits of
SERIAL No.
(Note-1)
14062 or later
15042 or later
15062 or later
16012 or later
17102 or later
16102 or later
16102 or later
17072 or later
17072 or later
18082 or later
First five digits of
GX Works2 SERIAL No.
(Note-1)
1.492N or later 14062 or later
1.492N or later 15042 or later
1.493P or later
1.507D or later 16012 or later
1.540N or later 17102 or later
1.525X or later 16102 or later
— 16102 or later
1.535H or later 17072 or later
1.540N or later 17072 or later
1.550Y or later 18082 or later
2 - 11
Chapter 2 System Configuration
QD77MS16
GX Works2
1.492N or later
1.492N or later
— —
1.507D or later
1.540N or later
1.525X or later
—
1.535H or later
1.540N or later
1.550Y or later
Reference
Appendix 6.2
Section 14.9
(Note-2)
Section 14.10
Section 5.2.7
Section 5.2.7
Section 5.6.1
Appendix 6.1
Appendix 6.5
Section 14.15
Appendix 6.3
Appendix 6.4
Section 14.11