Zp.pfwrt - Mitsubishi Electric QD77MS User Manual

15.5 ZP.PFWRT

Internal device
Setting
data
Bit
(S) –
(D)
[Instruction symbol]
ZP.PFWRT
[Setting data]
Setting data
Head I/O number of Simple Motion module
"Un"
(00 to FE: High-order two digits of I/O number expressed in three digits)
(S) Head number of a device in which control data is stored
Head number of a bit device which turns ON the operation by one scan at the
(D) time of completion of the instruction.
If the instruction is completed abnormally, ((D) + 1) will also be turned ON.
Note) The file register of each of the local device and the program cannot be used as a device for setting data.
(Note-1) : The data on the setting side is as follows.
• User : Data before the execution of dedicated instructions is stored by user.
• System: Data after the execution of dedicated instruction is stored by PLC CPU.
[Control data]
Device Item
(S)+0 System area
(S)+1 Complete status
(Note-1) : The data on the setting side is as follows.
• User : Data before the execution of dedicated instructions is stored by user.
• System: Data after the execution of dedicated instruction is stored by PLC CPU.
(Note-2): Refer to Section 16.4 for error codes at abnormal completion.
These dedicated instructions are used to write the parameters, positioning data, and
block start data of Simple Motion module to the flash ROM.
Link direct device J_\_
File
register
Word
–
[Execution condition]
Setting details
The state at the time of completion is stored.
0
Other than 0 : Abnormal completion (error code)
Usable device
Intelligent
function
Bit Word
–
–
Setting data
–
: Normal completion
15- 11
Chapter 15 Dedicated Instructions
Index
register
module
Zn
U_\G_
ZP.PFWRT "Un"
Setting side
(Note-1)
User
System
Setting
Range
(Note-2)
Constant
Others
K, H
– –
– –
(S) (D)
Data type
BIN 16 bits
– Device name
Bit
Setting side
(Note-1)
– –
– System