Mitsubishi Electric QD77MS User Manual page 128

If the adhesion of solvent and oil to the cord part of SSCNET
characteristic and machine characteristic. If it is used such an environment, be sure to do the
protection measures to the cord part.
When keeping the Simple Motion module or servo amplifier, be sure to put on a cap to
connector part so that a dirt should not adhere to the end of SSCNET
SSCNET connector to connect the SSCNET
inside connector from dust. For this reason, do not remove a cap until just before connecting
SSCNET cable. Then, when removing SSCNET
Keep the cap and the tube for protecting light cord end of SSCNET
with a zipper of SSCNET
When exchanging the Simple Motion module or servo amplifier, make sure to put cap on
SSCNET connector. When asking repair of Simple Motion module or servo amplifier for
some troubles, make also sure to put a cap on SSCNET
not put a cap, the light device may be damaged at the transit. In this case, exchange and repair
of light device is required.
Chapter 4 Installation, Wiring and Maintenance of the Product
CAUTION
cable to prevent them from becoming dirty.
4 - 10
cable may lower the optical
cable is put a cap to protect light device
cable, make sure to put a cap.
cable in a plastic bag
connector. When the connector is
connector.