Mitsubishi Electric QD77MS User Manual page 239

The following pages explain the block start data setting items [Da.11] to [Da.14].
(The buffer memory addresses shown are those of the "1st point block start data (block
No. 7000)".)
• Guide to buffer memory address
In the buffer memory address, "n" in "22000+400n", etc. indicates a value
corresponding to axis No. such as the following table.
Axis No. n Axis No.
1 0
2 1
3 2
4 3
(Note-1): Calculate as follows for the buffer memory address corresponding to each axis.
(Example) For axis No. 16
22000+400n ([Da.11] Shape)=22000+400 15=28000
(Note-2): The range from axis No.1 to 2 (n=0 to 1) is valid in the QD77MS2.
(Note-3): The range from axis No.1 to 4 (n=0 to 3) is valid in the QD77MS4.
Chapter 5 Data Used for Positioning Control
n Axis No.
5 4 9
6 5 10
7 6 11
8 7 12
5 - 101
n Axis No. n
8 13 12
9 14 13
10 15 14
11 16 15