Mitsubishi Electric QD77MS User Manual page 829

[1] Control details
Set the master axis and slave axis in the servo parameter.
Execute each control of Simple Motion module for the master axis. (However, be
sure to execute the servo ON/OFF of slave axis and error reset at servo alarm
occurrence in the slave axis.) The servo amplifier set as master axis receives
command (positioning command, speed command, torque command) from the
Simple Motion module, and send the control data to the servo amplifier set as
slave axis by driver communication between servo amplifiers.
The servo amplifier set as the slave axis is controlled with the control data
transmitted from master axis by driver communication between servo amplifiers.
Simple Motion
module
SSCNET (/H)
Positioning command/
speed command/
torque command
POINT
(1) When the communication is disconnected due to a fault in the servo amplifier, it
is not possible to communicate with the axis after the faulty axis. Therefore,
when connecting the SSCNET
position to the Simple Motion module.
(2) This function is used for the case to operate by multiple motors in one system.
Connect the master axis and slave axis without slip.
Master axis: Position command, speed command or torque command is received from Simple
Motion module.
Slave axis : Control data is received from Master axis by driver communication.
Master axis
[Driver
communication]
Control data 1
Control data 2
Control data 3
d1
Axis 1 Axis 2
ABS/INC INC
14 - 33
Chapter 14 Common Functions
Slave axis 1 Slave axis 2
[Driver
communication]
Control data 2
Control data 3
d2 d3
Axis 3
INC
cable, connect the master axis in the closest
Slave axis 3
[Driver
communication]
Control data 3
d4
Axis 4
INC