Fs-Fn Adjustment - Load Data; Fs-Fn Adjustment - Alignment Plate Position; Fs-Fn Adjustment - Paper Alignment Guides W. Adj - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012
12.16.6

FS-FN adjustment - Load Data

A. Use
• Register or call values adjusted for the finisher when it was installed at the customer site.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher] → [FS-FN adjustment] → [Load Data].
3. Select a mode from the following.
• Present adjusted value enrollment: Registers values adjusted for the finisher at the
installation.
• Enrollment lingua set point call: Calls values adjusted for the finisher at the installation.
4. Press the Start key.
5. Check that [OK] is displayed.
6. Touch [END].
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch. Then, wait for 10 sec. or more and turn ON the main
power switch.
12.16.7

FS-FN adjustment - Alignment Plate Position

A. Use
• When FS-529 is installed, use this feature to fine adjust the aligning plate that aligns
ejected paper.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher] → [FS-FN adjustment] → [Alignment Plate Position].
3. Select the [Alignment Plate Position (Back)] or [Alignment Plate Position (Side)].
The default setting is "0.0mm".
Adjustment range: -10.0 mm to +10.0 mm (1 step: 0.1 mm)
4. Set and adjust a value with the [+]/[-] key.
5. Touch [OK].
6. Touch [Exit] on the Service Mode screen.
7. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
12.16.8

FS-FN adjustment - Paper Alignment Guides W. Adj.

2
A. Use
• To fine adjust the horizontal width of the aligning plate.
• Use this feature to fine adjust the aligning plate that aligns ejected paper.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher] → [FS-FN adjustment] → [Paper Alignment Guides W. Adj.].
2
3. Select a mode from the following.
The default setting is "0.0mm".
Adjustment range: -10.0 mm to +10.0 mm (1 step: 0.1 mm)
4. Set and adjust a value with the [+]/[-] key.
5. Press the Reset key.
6. Touch [Exit] on the Service Mode screen.
7. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
12. SERVICE MODE
503
2