Konica Minolta bizhub C360 Service Manual page 640

Field Service Ver. 2.1 Feb. 2012
Code Item
C11B0 Stapler movement drive
malfunction
C11B2 Staple drive malfunction
C11B5 Saddle stapler drive mal-
function
C11C0 Punch motor drive mal-
function
C11E0 Duplex path switching
motor drive malfunction
Finisher route change
malfunction
Detection timing
<When FS-527 is installed>
• During home position search, neither the
stapler home sensor/1 (PS18) nor the sta-
pler home sensor/2 (PS19) is turned ON or
OFF even after the set period of time has
elapsed after the stapler movement motor
(M11) is turned ON.
<When FS-529 is installed>
• During the home position search, the stapler
home sensor (PS11) is not turned ON or
OFF even after the set period of time has
elapsed after the stapler movement motor
(M7) is turned ON.
<When FS-527 is installed>
• The stapler home sensor is turned neither
ON nor OFF even after the set period of
time has elapsed after the stapler motor is
turned ON.
<When FS-529 is installed>
• During the initial operation, the stapler home
sensor is not turned ON even after the set
period of time has elapsed after the stapler
movement motor (M7) is turned ON.
• The stapler home sensor is not turned ON
after the set period of time has elapsed after
the stapler motor (M8) is turned ON.
<When FS-527+SD-509 is installed>
• The center stapler home sensor is turned
neither ON nor OFF even after the set
period of time has elapsed after the center
stapler motor is turned ON.
<When FS-527+PK-517 is installed>
• The punch home sensor/1 (PS100) is not
turned ON even after the set period of time
has elapsed while the punch motor/1
(M100) is energized.
<When FS-527 is installed>
• The duplex path switching sensor (PS3) is
turned neither ON nor OFF even after the
set period of time has elapsed after the
duplex path switching motor (M2) is turned
ON.
<When JS-505 is installed>
• The route change home sensor (PS4) is not
blocked after the set period of time has
elapsed after the route change motor (M3)
is turned ON (start of shifting to the lower
tray route.)
• The route change home sensor (PS4) is not
unblocked after the set period of time has
elapsed after the route change motor (M3)
is turned ON (start of shifting to the upper
tray route.)
19. TROUBLE CODE
Trouble iso-
Rank
lation
Staple B
Staple B
Half-Fold/ B
Tri-Fold
Center
Stapling
⎯
B
⎯
B
⎯
B
585