Konica Minolta bizhub C360 Service Manual page 265

10. UTILITY
B. Symbol Set
(1) Use
• To set the font symbol set when not specified by the printer driver during PC printing.
• To use when the font symbol set cannot be specified by the printer driver during printing
from Windows DOS, etc.
(2) Procedure
• The default setting is Roman-8 or PC8, Code Page 437.
C. Font Size
(1) Use
• To set the font size when not specified by the printer driver during PC printing.
• To set the font size when it cannot be specified by the printer driver during printing from
Windows DOS, etc.
• To set scalable font (: Point) and bitmap font (: Pitch) respectively.
(2) Procedure
• The default setting is
Scalable Font : 12.00 points
Bitmap Font
D. Line/Page
(1) Use
• To set the number of lines per page for printing the text data.
(2) Procedure
• Default setting value differs depending on the values by the following two different set-
tings.
[Utility/Counter] → [User Setting] → [Printer Setting] → [Basic Setting] → [Original Direc-
tion]
[Utility/Counter] → [User Setting] → [Printer Setting] → [Paper Setting] → [Default Paper
Size]
E. CR/LF Mapping
(1) Use
• To set the mode for replacing data when printing the text data.
Mode 1 : CR → CR-LF LF=LF FF=FF
Mode 2 : CR=CR LF→CR-LF FF→CR-FF
Mode 3 : CR→CR-LF LF→CR-LF FF→CR-FF
OFF : Does not replace
(2) Procedure
• The default setting is OFF.
Mode 1
210
: 10.00 pitch
"60 or 64 lines" (5 to 128)
Mode 2
Field Service Ver. 2.1 Feb. 2012
Mode 3 "OFF"