Konica Minolta bizhub C360 Service Manual page 725

19. TROUBLE CODE
19.5.128 CC170: Dynamic link error during starting (AP0)
19.5.129 CC171: Dynamic link error during starting (AP1)
19.5.130 CC172: Dynamic link error during starting (AP2)
19.5.131 CC173: Dynamic link error during starting (AP3)
19.5.132 CC174: Dynamic link error during starting (AP4)
19.5.133 CC180: Dynamic link error during starting (LDR)
19.5.134 CC181: Dynamic link error during starting (IBR)
19.5.135 CC182: Dynamic link error during starting (IID)
19.5.136 CC183: Dynamic link error during starting (IPF)
19.5.137 CC184: Dynamic link error during starting (IMY)
19.5.138 CC185: Dynamic link error during starting (SPF)
19.5.139 CC186: Dynamic link error during starting (OAP)
MFP board (MFPB)
Step
1 If the malfunction code "C-C172" has
occurred, access [Service Mode] → [Sys-
tem 2] → [Image Controller Setting] and
check to see if "Controller 2," "Controller 3,"
or "Others" is set for [Image Controller Set-
ting].
If any of these is set, according to the kind
of controller, select "Controller 0" or "Con-
troller 1."
2 Change MFPB.
3 When not reviving even if the above-men-
tioned procedure is done, contact the
responsible people of KMBT.
19.5.140 CC190: Outline font load error
MFP board (MFPB)
Step
1 Check the connector between hard disk-
MFPB PJ11 for proper connection and cor-
rect as necessary.
2 Format hard disk.
3 Change hard disk
4 Change MFPB.
670
Relevant parts
Action
Relevant parts
Action
Field Service Ver. 2.1 Feb. 2012
NVRAM board (NRB)
WIRING DIAGRAM
Control signal
—
—
—
Hard disk
WIRING DIAGRAM
Control signal
—
—
—
—
Location (Electri-
cal component)
—
—
—
Location (Electri-
cal component)
—
—
—
—