Troubleshooting; 17. Jam Display; 17.1 List Of Jam Code - Konica Minolta bizhub C360 Service Manual

Field Service Ver. 2.1 Feb. 2012

TROUBLESHOOTING

17. JAM DISPLAY

• When the paper jam occurred, the message, the position jam occurred (number blinks),
position of the remaining paper (number lights up), and the JAM code are displayed.
NOTE
• JAM code is displayed on the jam warning screen only when the following setting
is set to "Display."
[Service Mode] → [System 2] → [JAM Code Display Setting]

17.1 List of JAM code

JAM
JAM type
code
10-01 Manual bypass
feed section
10-02
10-40
10-44
Detection timing
• The leading edge of the paper does not
unblocked the sensor in front of tim. roller
(PS1) even after the lapse of a given
period of time after the manual bypass
starts to feed paper.
• For paper fed from the manual bypass,
loop forming has not been complete
before a sheet enters the timing roller
because the rise timing of load to perform
registration is earlier than the rise timing of
load to form a loop.
• For paper fed from the manual bypass, the
image write start signal permit continues
to be disabled for a predetermined period
of time after the timing of the image write
start signal output.
• At the start of paper feed retry, the sensor
in front of tim. roller (PS1) has already
detected paper passage.
17. JAM DISPLAY
A0EDF4E510DA
Misfeed processing Ref.
location page
Right door P.554
537