Konica Minolta bizhub C360 Service Manual page 674

Field Service Ver. 2.1 Feb. 2012
19.5.4 C0206: Tray3 lift-up failure
19.5.5 C0208: Tray4 lift-up failure
Tray3 lift-up motor (M124)
Tray4 lift-up motor (M125)
Tray3 upper limit sensor (PS114)
Tray4 upper limit sensor (PS123)
Step
1 Check the connector between M124-PCCB
CN4 for proper connection and correct as
necessary.
2 Check the connector between M125-PCCB
CN8 for proper connection and correct as
necessary.
3 Check the connector between PS114-
PCCB CN6 for proper connection and cor-
rect as necessary.
4 Check the connector between PS123-
PCCB CN10 for proper connection and cor-
rect as necessary.
5 Check the connector of each motor for
proper drive coupling, and correct as nec-
essary.
6 PS114 I/O check, sensor check
7 PS123 I/O check, sensor check
8 M124 operation check
9 M125 operation check
10 Change PRCB
11 Change MFPB
Relevant parts
Action
PC Control board (PCCB)
MFP board (MFPB)
WIRING DIAGRAM
Control signal
—
—
—
—
—
PCCB CN6-3 (ON)
PCCB CN10-3 (ON)
PCCB CN4-4 (ON)
PCCB CN8-12 (ON)
—
—
19. TROUBLE CODE
Location (Electri-
cal component)
—
—
—
—
—
PC-207 B-1
PC-207 G-4
PC-207 B-4
PC-207 G-1
—
—
619