Printer Area-Prt. Image Center. Side 2 (Dup) - Konica Minolta bizhub C360 Service Manual

12. SERVICE MODE
12.4.7

Printer Area-Prt. Image Center. Side 2 (Dup)

2
A. Use
• To vary the print start position in the main scan direction for each paper source in the 2-
Sided mode.
• The image on the backside of the 2-sided copy deviates in the main scan direction.
B. Procedure
• Width A on the test pattern produced should fall within the following range.
• For measurement, use the image produced on the backside of the test pattern.
Specifications: 3.0 ± 0.5 mm
1. Call the Service Mode to the screen.
2. Touch [Machine] → [Printer Area] → [Prt. Image Center. Side 2 (Dup)].
2
3. Select the paper source to be adjusted.
4. Press the Start key to let the machine produce a test print.
5. Check the dimension of width A on the test print.
6. If width A falls outside the specified range, change the setting using the [+] / [-] key.
If width A is longer than the specifications, make the setting value smaller than the cur-
rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
7. Press the Start key to let the machine produce a test print.
8. Check the dimension of width A on the test print on the backside of the copy.
9. If width A is outside the specified range, change the setting again and make a check
again.
10. If width A falls within the specified range, touch [END].
11. Following the same procedure, adjust for all other paper sources.
(Use A4 or 8
376
2
Width A
/ x 11 plain paper for the manual bypass tray.)
1
2
Field Service Ver. 2.1 Feb. 2012
Backside
A0P0F3C504DA