Konica Minolta bizhub C360 Service Manual page 688

Field Service Ver. 2.1 Feb. 2012
19.5.26 C1191: Alignment plate F drive malfunction
(1) When FS-529 is installed
Alignment motor/F (M3)
Alignment plate home sensor/F (PS8)
Step
Check the connector between M3-FSCB
1 CN14 for proper connection and correct as
necessary.
Check the connector between PS8-FSCB
2 CN6 for proper connection and correct as
necessary.
Check the connector of M3 for proper drive
3
coupling, and correct as necessary.
4 PS8 I/O check, sensor check
5 M3 operation check
6 Change M3
7 Change FSCB
19.5.27 C1194: Leading edge stopper motor drive malfunction
(1) When FS-527 is installed
Leading edge stopper motor (M14)
Leading edge stopper home sensor (PS20)
Step
Check the connector between M14-FSCB
1 PJ8 for proper connection and correct as
necessary.
Check the connector between PS20-FSCB
2 PJ17 for proper connection and correct as
necessary.
Check the connector of M14 for proper
3
drive coupling, and correct as necessary.
4 PS20 I/O check, sensor check
5 M14 operation check
6 Change M14
7 Change FSCB
Relevant parts
Action
Relevant parts
Action
FS control board (FSCB)
WIRING DIAGRAM
Control signal
—
—
—
FSCB CN6-6 (ON)
FSCB CN14-1 to 4
—
—
FS control board (FSCB)
WIRING DIAGRAM
Control signal
—
—
—
FSCB PJ17-6 (ON)
FSCB PJ8-9 to 12
—
—
19. TROUBLE CODE
Location (Electri-
cal component)
—
—
—
FS-529 B-1
FS-529 G-2
—
—
Location (Electri-
cal component)
—
—
—
FS-527 B to C-8
FS-527 B to C-6
—
—
633