Konica Minolta bizhub C360 Service Manual page 206

Field Service Ver. 2.1 Feb. 2012
8. Press the [START]. (At this time, the Start key starts blinking red.)
9. Check that the control panel shows the message indicating that the data has been
rewritten correctly ([Downloading Completed]). Check also the check sum value
([Check Sum ####]) shown on the control panel. (The Start key lights blue.)
10. Turn OFF the main power switch and the sub power switch.
11. Remove the USB memory device, and fix the cover of the USB port using a screw.
12. Turn ON the main power switch and the sub power switch.
NOTE
• When turning the main power switch ON for the first time after the firmware is
updated, data may sometimes be internally updated.
In that case, the following message will be displayed. Never turn the main power
switch OFF until either the serial number input screen or the trouble code screen
is displayed.
13. Call the Service Mode to the screen.
14. Select [Firmware Version].
15. Make sure if the version of firmware is updated.
7. FIRMWARE REWRITING
A00JF2E582DA
151