12. SERVICE MODE
12.16.3
FS-FN adjustment - Punch Edge Adj
2
A. Use
• To change the horizontal position of the punch holes.
B. Procedure
1. Make a copy sample in the punch mode.
2. Make an adjustment so that the width B is within the following range.
Specification B: 9.5 mm ± 1.0 mm (2-3 hole), 11.0 mm ± 1.0 mm (2-4 hole),
10.5 mm ± 1.0 mm (SWE4 hole)
Adjustment range: -10.0 mm to +10.0 mm (1 step: 0.1 mm)
3. Call the Service Mode to the screen.
4. Touch [Finisher] → [FS-FN adjustment] → [Punch Edge Adj].
2
5. Touch the paper type where punch horizontal position is adjusted.
6. Look at the copy and adjust the punch horizontal position with the [+]/[-] key.
To make width B greater: Enter the value of [+]
To make width B smaller: Enter the value of [-]
7. Press the Reset key.
8. Touch [Exit] on the Service Mode screen.
9. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
10. Make another set of copy sample and check the amount of deviation (A).
500
2
Field Service Ver. 2.1 Feb. 2012
B
A11TF3C502DA
A11TF3C503DA