Field Service Ver. 2.1 Feb. 2012
12.16.4
FS-FN adjustment - Punch Regist Loop Size
A. Use
• Adjusts the punch loop size used for paper exited from the main body.
• To address problems such as misaligned punch holes, wrinkled paper, and jam at the
punch registration section.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher] → [FS-FN adjustment] → [Punch Regist Loop Size].
3. Touch the paper size where punch regist loop size is adjusted.
4. Set the correction value using the [+]/[-] keys.
Misaligned punched holes: Enter the value of [+]
Wrinkled paper: Enter the value of [-]
Adjustment range: -4.0 to +4.0
5. Press the Reset key.
6. Touch [Exit] on the Service Mode screen.
7. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
12.16.5
FS-FN adjustment - Finisher Components Test Mode
2
A. Use
• Use this adjustment to check finisher's operation.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Finisher] → [FS-FN adjustment] → [Finisher Components Test Mode].
2
3. Touch [1] or [2] to select a mode.
4. Press the Start key to start finisher operation.
5. Press the Stop key to stop ongoing finisher operation.
12. SERVICE MODE
501
2