Setup Confirmation; Calling The Maintenance - Konica Minolta bizhub C360 Service Manual

12. SERVICE MODE
SW No.
23
Bit
7-0 Original-based misfeed frequent occurrence
threshold value
12.7.4

Setup confirmation

• Follow the steps below to make sure that CS Remote Care has been properly set
up.
1. Call the Service Mode to the screen.
2. Touch [CS Remote Care].
3. Check to make sure that only selected item is displayed.
12.7.5

Calling the maintenance

• When CE starts maintenance, inputting the ID code of CE (seven digits: numbers which
CE can identify. They are controlled by the distributor.) will transmit the information to the
Center side and tells that the maintenance has started. When the maintenance is fin-
ished, touching [Maintenance Complete] key will transmit the information to the center
and tells that it is finished.
A. When starting the maintenance
1. Select Service Mode and touch [CS Remote Care].
2. Touch [ID Code], and input ID Code.
3. Touch [ID Coke].
* The Start key blinks while maintenance is being carried out.
B. When finishing the maintenance
1. Select Service Mode and touch [CS Remote Care].
2. Touch [Maintenance Complete].
412
Default
7654 3210
Bit
0000 0101
Functions
Field Service Ver. 2.1 Feb. 2012
HEX: 05
Logic
0 1
0000 0001 1
0000 0010 2
: :
0000 0101 5
: :
0000 1110 14
0000 1111 15
Others Not available
Description