Konica Minolta bizhub C360 Service Manual page 594

Field Service Ver. 2.1 Feb. 2012
JAM
JAM type
code
⎯
Tray 2 feed
section
⎯
13-01 Tray 3 feed
section
⎯
13-40 Tray3 feed sec-
tion image
write start sig-
nal permit
waiting jam
14-01 Tray 4 feed
section
⎯
14-40 Tray4 feed sec-
tion image
write start sig-
nal permit
waiting jam
Detection timing
• Paper feed tray 2 paper feed sensor
(PS20) is turned ON when the main power
switch is turned ON, a door or cover is
opened and closed, or a misfeed or mal-
function is reset.
(bizhub C360/C280 only)
• In case paper position is detected as
locating properly after main power switch
is turned ON, door and cover are opened /
closed or jam/trouble reset is done, it is
regarded as paper jam at tray 2 feed sec-
tion.
• The leading edge of the paper does not
block the tray3 vertical transport sensor
(PS117) even after the set period of time
has elapsed after the tray3 paper feed
motor (M122) is energized.
• The tray3 paper feed sensor (PS116) is
blocked when the main power switch is set
to ON, a door or cover is opened and
closed, or a misfeed or malfunction is
reset.
• For paper fed from the tray3, image write
start signal permit continues to be dis-
abled for a predetermined period of time
after the timing of image write start signal
output.
• The leading edge of the paper does not
block the tray4 vertical transport sensor
(PS126) even after the set period of time
has elapsed after the tray4 paper feed
motor (M123) is energized.
• The tray4 paper feed sensor (PS125) is
blocked when the main power switch is set
to ON, a door or cover is opened and
closed, or a misfeed or malfunction is
reset.
• For paper fed from the tray4, image write
start signal permit continues to be dis-
abled for a predetermined period of time
after the timing of image write start signal
output.
17. JAM DISPLAY
Misfeed processing Ref.
location page
Right door P.555
Tray 2
Right door P.556
Tray 3
Right door P.556
Tray 4
539