Konica Minolta bizhub C360 Service Manual page 331

10. UTILITY
K. IPsec Settings-Peer
(1) Use
• To register destinations used for IPsec communication.
• Settings can be made independently for different ten sets (Group 1 to 10).
(2) Procedure
<Peer>
• Among Group 1 to 10, select a group where settings are made.
• After touching the key of the Group, make the following setting.
<Encapsulation Mode>
• Set a encapsulation mode used for IPsec.
• The default setting is OFF.
Tunnel Mode
<IP Address>
• When the encapsulation mode is set, specify the IP address of destinations.
• Touch [IP Address] and enter the IP address with IPv4 or IPv6 format.
<Pre-Shared Key Text>
• When the encapsulation mode is set, specify a Pre-shared key (Key data).
• Touch [Input] and enter the Pre-shared key.
<Perfect Forward Secrecy>
• When the transport mode is selected, set whether to use Perfect forward secrecy.
• The default setting is OFF.
L. IP Filtering (Permit Access)
(1) Use
• To set the IP filtering (Permit Access).
• To set whether to allow only IP addresses that are within a specified range.
(2) Procedure
1. Select Enable or "Disable".
2. When [Enable] is set, select one from Set 1 to Set 5 and specify the range of IP
addresses to be allowed using the 10-key pad.
3. Touch [OK].
M. IP Filtering (Deny Access)
(1) Use
• To set the IP filtering (Deny Access).
• When [Enable] is set, select one from Set 1 to Set 5 and specify the range of IP
addresses to be allowed using the 10-key pad.
(2) Procedure
1. Select Enable or "Disable".
2. When [Enable] is set, select one from Set 1 to Set 5 and enter the range of IP
addresses to be denied using the 10-key pad.
3. Touch [OK].
276
Transport Mode
ON
Field Service Ver. 2.1 Feb. 2012
"OFF"
"OFF"