System Settings-Output Settings - Konica Minolta bizhub C360 Service Manual

10. UTILITY
B. Sleep Mode Settings
(1) Use
• To set the time until sleep mode starts operating after the last key operation has been
completed.
• Turn all lines OFF except 5 V line for control.
• "OFF" will only be displayed when [Sleep ON/OFF Choice Setting] in Service Mode is
2
set.
(2) Procedure
• Use the 10-key pad for setting.
• The default setting is 30 min.
10.5.6

System Settings-Output Settings

• It will be displayed only when the following setting is set to "Level 2."
[Administrator Settings] → [Security Settings] → [Administrator Security Levels]
• It will not be displayed when the following setting shows that authentication device or the
vendor is mounted.
[Service Mode] → [Billing Setting] → [Management Function Choice]
(It will be displayed when the key counter is mounted.)
A. Print/Fax Output Settings
(1) Use
• To set the timing for printing for the PC print job or fax received.
Batch Print : Starts printing when all data are received
Page Print : Starts printing every time data for each page are received
(2) Procedure
<Printer>
• The default setting is Page Print.
<Fax>
• The default setting is Batch Print.
NOTE
• [FAX] will be displayed only when the optional fax kit (FK-502) is mounted.
B. Output Tray Setting
• It will be displayed when the optional finisher FS-527 or the job separator JS-505 is
mounted.
(1) Use
• To set the priority output tray for each application (Copy print, Printer, Fax and Print
Reports).
(2) Procedure
• The default settings are as follows.
Copy
Print
Report Output : Tray 2
Fax
• [Tray 3] will be displayed only when the job separator JS-603 is mounted to the finisher
FS-527.
190
2
"30 min." (15 to 240) / OFF
: Tray 1
: Tray 1
: Tray 2
Field Service Ver. 2.1 Feb. 2012