Non-Image Area Erase Check; 12.5 Firmware Version - Konica Minolta bizhub C360 Service Manual

12. SERVICE MODE
12.4.23

Non-Image Area Erase Check

A. Use
• The non-image area erase function may not work properly under bright light source.
Incoming light quantity is checked to verify that the non-image area erase function can
work properly under the environment.
• Verification results are shown as follows:
OK : Works properly.
NG1 : Works properly. However, data that may interfere with the non-image area
erase function was found. This function may not work well with dark original.
NG2 : Data that may interfere with the non-image area erase function was found.
• Use this feature when installing a new machine or reinstalling a machine in a new place.
• Use this feature when the non-image area erase function fails to work properly due to the
changes of the surrounding environment at the installation site.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch these keys in this order: [Machine] → [Non-Image Area Erase Check].
3. Press the Start key to start a check.
NOTE
• Before the check, make sure that the ADF or original cover is completely opened.
In addition, make sure that no scratch or stain exists on the original glass.
4. Check the result is "OK."
✽ If the check result is "NG1" or "NG2," reinstall the machine in another place or adjust the
orientation of the machine to reduce light incidence on the machine. Then, perform the
check again.

12.5 Firmware Version

A. Use
• To check the firmware version.
• Use when the firmware is upgraded.
• When the firmware is upgraded or PWB is replaced.
B. Procedure
1. Call the Service Mode to the screen.
2. Touch [Firmware Version].
3. Select the appropriate key from 1 to 3 to check the Firmware Version.
390
Field Service Ver. 2.1 Feb. 2012