Updating The Firmware; Software Update; Software Update Procedure; Doing The Software Update Procedure - Ricoh D131 Service Manual

5.4 UPDATING THE FIRMWARE

5.4.1 SOFTWARE UPDATE

Software Update Procedure

SD cards are used to update the software and to back up important data. Here is a list of the
firmware modules that can be updated or restored from an SD card:

GW controller software

BCU software

LCDC (operation panel) software

Network Sys (network) software

Web Sys (Web Image Monitor)

Document Server software

NFA (Net File) software

Printer application software

Scanner application software

DESS (encryption module) software

Never connect or remove an IC card or SD card with the machine power turned on.

Never turn the power off while the machine is downloading data from an IC card or SD
card.

The IC cards and SD card are precision items. Use them carefully.

Never store IC cards or SD cards in a location where they are exposed to high
temperature, high humidity, or direct sunlight.

Never bend an IC card or SD card, scratch it, or expose it to strong vibration.

Before uploading data to an SD card, always confirm that its write-protect switch is off.

Doing the Software Update Procedure

An SD card with the software downloaded to it is necessary for this procedure.
1. Turn the main switch off.
2. Remove the SD card slot cover (
3. Hold the SD card (the surface with printing must be away from the front of the machine), and
install the SD card in slot 2.
4. Turn the main power switch on.
5. Stop until the version update screen is displayed. If the SD card contains more than one
software application, the screen will be almost the same as the one below. The screen below
shows that the SC card contains two applications: "Engine" and "Printer".
SM
x 1).
5-15
Updating the Firmware
D131/D132/D133