ADF
4.13.3 FEED BELT AND PICK-UP ROLLER
1.
Remove the feed unit.
2.
Remove the pick-up roller unit [A].
3.
Remove the bushings [B].
4.
Remove the pick-up roller [C].
At re-assembly, make sure that the tab on the front guide plate is above the pick-up
roller.
5.
Hold the feed belt holder [A] by the left and right sides, then carefully pull it off the bushing. Do
not let the springs [B] fall.
6.
Remove the feed belt [C].
When re-assembling, set the pick-up roller springs first, then follow this procedure in
reverse.
D131/D132/D133
p.4-137
4-138
SM