Re-Installation - Ricoh D131 Service Manual

Transfer Belt Unit

Re-installation


Before re-assembling the transfer belt unit, use a clean cloth and alcohol to clean the contact
points of the drive roller, idle roller, and transfer roller. Make sure these areas are clean and
free from toner, paper dust, etc.

Never touch the surface of the belt with bare hands and never apply alcohol to the surface of
the belt. Clean it with a blower brush. Check the underside of the transfer belt and clean with
the blower brush.

When re-assembling the transfer belt unit, make sure that the transfer belt is centered
between the triangular marks [A] on either side of the unit.

After re-assembly, make sure that the transfer belt is inside the transfer current terminal. The
belt could be cut if it is not positioned correctly.

Confirm that both the ground and transfer current terminal are connected and that the
harnesses are not touching the release lever.

After re-installing the transfer belt unit, turn the belt and confirm that the toner collection coil
turns.

The transfer belt and transfer roller cleaning blade must always be replaced together.
D131/D132/D133 4-66 SM