Registration Buckle Adjustment - Ricoh D131 Service Manual

Copy Image Adjustments: Printing/Scanning

Registration Buckle Adjustment

When the customer is using special paper, buckle adjustment may be required if paper feed
problems arise.

If the buckle is too large, this can cause wrinkling, creasing, or jams caused by sheets
overtaking the sheets ahead of them in the paper path.

If the buckle is too small, this can cause jams at the registration roller or skew during paper
feed.
1. Enter the SP mode.
2. Open SP1003.

To prevent wrinkling, creasing, or jams, set a smaller value.

To prevent jams at the registration roller or to eliminate skew, set a larger value.
SP1003-001
SP1003-002
SP1003-003
Adjustment range
Initial value
D131/D132/D133
Registration Buckle Adjustment – Tray, LCT
Registration Buckle Adjustment – Duplex Tray
Registration Buckle Adjustment – Bypass Tray
-9 mm  +9 mm (small  large buckle)
0 mm (Buckle = 10 mm)
4-158 SM