Transfer Belt Unit
4.8 TRANSFER BELT UNIT
4.8.1 TRANSFER BELT UNIT REMOVAL
Before you begin, spread a mat or some clean paper on the floor where you intend to set
the transfer belt unit.
Remove:
OPC drum unit
1.
Disconnect the transfer belt unit [A] (
2.
Remove the transfer belt unit stay [B] (
3.
While supporting the transfer belt unit with your hand, turn the release lever [C]
counter-clockwise to release it, then pull the transfer belt unit out of the machine.
The transfer belt unit can be removed without removing the OPC drum unit.
However, the transfer belt unit must be removed carefully to avoid scratching the
surface of the transfer belt on the OPC drum unit [D].
Avoid touching the belt with bare hands.
D131/D132/D133
p.4-40
x 1).
x 1).
4-64
SM