Power Requirements - Ricoh D131 Service Manual

Installation Requirements

2.1.6 POWER REQUIREMENTS

Make sure that the wall outlet is near the main machine and easily accessible. Make sure
the plug is firmly inserted in the outlet.
Avoid multi-wiring.
Be sure to ground the machine.
Never set anything on the power cord.
⇒
Input voltage level
Permissible voltage fluctuation ±10%
Never turn off the main power switch when the power LED is lit or flashing. To avoid
damaging the hard disk or memory, press the operation power switch to switch the power
off, wait for the power LED to go off, and then switch the main power switch off.
The Main Power LED lights or flashes at the following times:
While the platen cover or ADF is open
While the main machine is communicating with the network server
While the machine is accessing the hard disk or memory when reading or writing data.
There are two power switches on the machine:
Main Power Switch: Located on the front left corner of the machine and covered by a plastic
cover. This switch should always remain on unless the machine is being serviced.
Operation Power Switch: Located on the right side of the operation panel. This is the switch
normally used by the customer to power the machine on and off.
D131/D132/D133
North America 120 V, 60 Hz: 20 A or more (D131/D132)
208-240, 60Hz, 12A (D133)
Europe/Asia 220 V to 240 V, 50 Hz/60 Hz: 10 A or more
2-6
Rev. 08/30/2012
SM