Installation; Before You Begin: Checklists; Slave Procedure I - Ricoh D131 Service Manual

1.4.4 INSTALLATION

Before You Begin: Checklists

Check the machine to be set up as the master. The following items must be installed in the master
machine.

Printer/Scanner Unit Type 9002 (D620). Installation is described in the Field Service Manual.
The P/S SD card must be in SD card Slot 1.

Fax Option Type 9001 (D619). This is the FCU. Installation is described in this manual.

G3 Interface Unit Type 9002 (D619). At least one G3 unit is required. Installation is described
in this manual.
Check the machines to be slaved. The following item must be installed in a slave machine.

Printer/Scanner Unit Type 9002 (D620). Installation is described in the Field Service Manual.
The P/S SD card must be in SD card Slot 1. Installation is described in the Field Service
Manual.
These items must be installed in the master and slave machines before doing the procedures
below.

Slave Procedure I

1. Turn the machine off and disconnect it from its power source.
2. Remove the SD card slot cover (
3. Confirm that the Printer/Scanner SD card is in Slot 1.
4. With its label turned away toward the front of the machine, insert Remote Fax Card Type 31
into SD card slot 2 (lower slot). Push it in until you hear it click and lock in place.
5. Connect the machine power cord to its power source, and then turn the machine on.
6. Enter the SP mode.
7. Do SP5-873-1 to move the fax connection application from the SD card in Slot 2 (lower slot)
to the Printer/Scanner SD card in Slot 1 (upper slot).
8. Switch the machine off.
9. Remove the remote fax SD card from Slot 2, and then store it in a safe place.
D619
x1).
32 SM