Ricoh D131 Service Manual page 371

Module mismatch - Correct
34
module is not on the SD card
Module mismatch – Module on
35
SD card is not for this machine
Cannot write module – Cause
36
other than E34, E35
Engine module download
40
failed
Operation panel module
42
download failed
Stamp data module download
43
failed
Controller module download
44
failed
Electronic confirmation check
50
failed
SM
The data on the SD is not correct. Get the correct
data (Japan, Overseas, OEM, etc.) then install
again.
SD update data is not correct. The data on the SD
card is for a different machine. Get the correct
data then install again.
SD update data is not correct. The data on the SD
card is for a different machine. Get the correct
data then install again.
Replace the data for the module on the SD card
and try again, or replace the BCU board.
Replace the data for the module on the SD card
and try again, or replace the LCDC.
Replace the data for the module on the SD card
and try again, or replace the hard disk.
Replace the data for the module on the SD card
and tray again, or replace the controller board.
SD update data is not correct. The data on the SD
card is for a different machine. Get the correct
data then install again.
5-19
Updating the Firmware
D131/D132/D133