Button Selection Entry - Ricoh D131 Service Manual

Button Selection Entry

1. Refer to the SP Mode Tables at the end of this section to find the SP that you want to adjust.
2. Press the Group number on the left side SP Mode window that contains the SP that you want
to adjust.
3. Use the scrolling buttons in the center of the SP mode window to display the SP number that
you want to open, then press that number to expand the list.
4. Use the center touch-panel buttons to scroll to the number and title of the item that you want
to set, and press [#]. The small entry box on the right is activated and displays the default or
the current setting below.
5. To enter a setting

Press [./*] to enter a minus sign. Then use the keypad to enter the appropriate number.
The number you enter will write over the previous setting.

Press [#] to enter the setting. (If you enter a number that is out of range, the key press is
ignored.)

When you are prompted to complete the selection, press Yes.
6. If you need to perform a test print, press Copy Window to open the copy window and select
the settings for the test print. Press [Start] twice, then press SP Mode (highlighted) in the copy
window to return to the SP mode display.
7. When you are finished, press Exit twice to return to the copy window.
SM 5-7
Service Program Mode
D131/D132/D133