Before You Use The Tables - Ricoh D131 Service Manual

2.1.3 BEFORE YOU USE THE TABLES

The following notations are used to identify which finisher the SC codes refer to.
Notation
D610 Finisher SR4080 (D610)
D611 Finisher SR4060 (D611)
D612 Finisher SR4070 (D612)
D615 Multi Folding Unit FD4000 (D615)
Only one of these finishers can be installed in the system. Many of the SC codes apply to more
than one finisher because they have nearly identical parts and part names.
Example'
Exit guide motor (D610/D611/D612)
725 B
The status of the exit guide sensor did not change at the prescribed time
during operation of the exit guide.

Exit guide open sensor loose, broken, defective.

Exit guide motor defective

Finisher main board defective
SC725 applies to the exit guide motor of whichever finisher is installed: The SR4080, the SR4060,
or the SR4070

If a problem concerns electrical circuit boards, always disconnect then reconnect the
connectors before replacing the PCBs.

If a motor lock error occurs, first check the mechanical load before replacing motors or
sensors.

When a Level "A" or "B" SC occurs while in an SP mode, the display does not display the
SC number. If this occurs, check the SC number after leaving the SP mode.
SM Appendix
Finisher
2-3
Service Call Conditions
D131/D132/D133