Two G3 Interface Units Installation - Ricoh D131 Service Manual

32. Connect the harnesses between the speaker unit and the FCU/G3 (
33. Reattach:

Controller box cover (

Rear lower cover (

Rear upper cover (

Two G3 Interface Units Installation

1. Do Steps 1 through 9 of the previous procedure.
2. Release the three clamps on the second G3 unit.
3. Remove the G3 board [A] from the second G3 interface unit [B] (
4. Push the G3 board [A] into the edge connector of the first G3 interface unit [B] (
5. Make sure that the edge connection is secure.
6. Fasten the board from the 2nd G3 unit (
SM
x 13).
x 2).
x 2).
x2).
21
x4, x2).
x 2).
x1).
D619