Ricoh D131 Service Manual page 108

Finishers SR4060/SR4070 (D611/D612)
2. If the "Exit Tray Full" alerts continue, set the proof auxiliary tray [A] on the proof tray on the top
of the finisher.
3. Make sure that the arms
below.
Shift Auxiliary Tray
1. Open and close the front door of the finisher. This initializes the finisher and moves the shift
tray to the standby position.
2. Open the front door again and leave it open.
3. Set the shift auxiliary tray [A] on the shift tray as shown.
4. Close the front door. This initializes the finisher again and moves the shift tray to the new
standby position with the auxiliary tray installed.
5. After the Z-folding job is finished, remove the tray and store it in the auxiliary tray storage
pocket on the back of the finisher.
6. Open and close the front door to re-initialize the finisher and reset the standby position of the
shift tray.
D131/D132/D133
of the auxiliary tray fit tightly over the ridges
2-64
of the proof tray
SM