Use the two small tapping screws that are supplied, and not the machine screws
removed from the finisher guide plate.
6.
Release the lock lever [D] (
7.
Attach the pad [E]. (This pad is provided with the finisher.)
8.
Slowly push the finisher against the side of the machine until the brackets [F] go into the slots.
Move the finisher carefully, or you will bend the entrance guide plates.
9.
Attach the lock lever [D] (
10. Connect the connector [G] to the copier.
Check the duct [A] on the left side of the machine.
Make sure that the sponge does not prevent air flow through this duct.
SM
x 1).
x 1).
2-83
Cover Interposer Tray CI4000 (D614)
D131/D132/D133