Ricoh D131 Service Manual page 721

SP5000 Mode: SP5821 to SP5990
This SP must be executed immediately after installation of an HDD unit in a
basic machine that previously had no HDD. The first time the machine is
powered on with the new HDD installed, the system automatically takes the
address book from the NVRAM and writes it onto the new HDD. However, the
new address book on the HDD can be accessed only by the system
administrator at this stage. Executing this SP by the service technician
immediately after power on grants full address book access to all users.
Procedure
1. Turn the machine off.
41
2. Install a new HDD.
3. Turn the machine on.
4. The address book and its initial data are created on the HDD automatically.
5. However, at this point the address book can be accessed by only the
system administrator or key operator.
6. Enter the SP mode and do SP5846-041. After this SP executes
successfully, any user can access the address book.
Addr Book Media
Displays the slot number where an address book data is in.
[0 to 30 / - /1]
0: Unconfirmed
1: SD Slot 1
43
2: SD Slot 2
4: USB Flash ROM
20: HDD
30: Nothing
Initialize Local Addr Book
47 Clears the local address book information, including the user code.
Initialize Delivery Addr Book
48 Clears the distribution address book information, except the user code.
Initialize LDAP Addr Book
49 Clears the LDAP address book information, except the user code.
Initialize All Addr Book
D131/D132/D133 3-146 SM Appendix