Ricoh D131 Service Manual page 369


The bottom bar is a progress bar. The "_" marks in the progress bar are replaced by "*"
marks. This progress bar cannot be displayed during the firmware update for the
operation panel. But, the LED of the [Start] key on the operation panel changes from red
to green to show that the update of the operation panel firmware continues.

When the update is completed, you will see this screen.
After the firmware update, you will see "Update Done" in the first bar. The name of the module
in the bottom bar is the name of the last module that was updated (only the name of the last
module is shown, if several modules were been updated).
8. Turn the power off and on. Then, select the items that you updated, and then push the [Verify]
button. This is to check that the modules were updated correctly.
9. If you see "Verify Error" in the first bar on the screen, then you must do the procedure again
for the module shown in the bottom bar.

The "Verify" procedure is not necessary but it is strongly recommended.
10. After the firmware is correctly updated, turn the main power switch off.
11. Push the SD card in a small distance to release it, then pull it out of the slot.
12. Turn the main power switch on, and check that the machine operates correctly.
SM 5-17
Updating the Firmware
D131/D132/D133