SC200: Exposure
2.3 SC200: EXPOSURE
2.3.1 SC200
Polygon mirror motor error 1: Timeout at ON
D
The polygon mirror motor unit did not enter "Ready" status within 20
sec. after the motor was turned on,
SC202
-
Polygon mirror motor error 2: Timeout at OFF
The polygon mirror motor did not leave "Ready" within 3 sec. after the
D
motor was switched off. (The XSCRDY signal did not go HIGH (inactive)
within 3 sec.)
SC203
-
Polygon mirror motor error 3: XSCRDY signal error
The polygon mirror motor "Ready" signal goes inactive (HIGH) while
D
images are being produced or the synchronization signal is being
SC204
output.
-
D131/D132/D133
The polygon mirror motor PCB connector is loose, broken, or
defective
Polygon mirror motor PCB defective
Polygon mirror motor defective
IPU defective
The polygon mirror motor PCB connector is loose, broken, or
defective
Polygon mirror motor PCB defective
Polygon mirror motor defective
IPU defective
Polygon mirror motor PCB connector loose, broken, defective
Polygon mirror motor PCB defective
Polygon mirror motor defective
2-10
SM Appendix