Ricoh D131 Service Manual page 767

SP6000 Peripherals
13 Length Sensor 1
14 Length Sensor 2
15 Length Sensor 3
Stamp Unit
Sets the stamp unit to set or unset.
6801
[0 to 1/1]
0: set, 1: unset
Extra Staples
More than the standard number of corner staples can be loaded.
This SP recognizes the maximum number of staples (This Setting + Standard
Number).

If the number of the maximum for staples is increased, and the
6830
mechanical warranty of the unit can be guaranteed, then the setting can
take effect without changing the controller software.

However, assurance that mechanical performance can be guaranteed is
required before changing the setting to increase the staple load for more
than the maximum in the feed / exit specifications. Raising this setting
without quality assurance could damage the machine.
0 to 50 (Initial: 0)
1
[0 to 50 /0/1]
0 to 50 (Initial: 0)
2
[0 to 50 /0/1]
Punch Function Enabled Z-Fold
6890
Switches punchin off/on.
[0 to 1/1/0] 0:Punch Off 1:Punch On
D131/D132/D133
[0 to 1 / 0 / 1]
[0 to 1 / 0 / 1]
[0 to 1 / 0 / 1]
3-192 SM Appendix