Ricoh D131 Service Manual page 873

Input/Output Check
20 APS Start Sensor
21 Bottom Plate HP Sensor
22 Bottom Plate Posirion Sensor
3.13.4 ADF OUTPUT CHECK: SP6008
1. Open SP mode SP6008.
2. Select the SP number that corresponds to the component you wish to check. (Refer to the
table below.)
3. Press On then press Off to test the selected item. You cannot exit and close this display until
you click Off to switch off the output check currently executing.
ADF Output Check
6008
Turns on the ADF electrical components individually for testing.
1 Feed Motor: Forward
2 Feed Motor: Reverse
3 Transport Motor: Forward
4 Exit Motor: Forward
8 Stamp Solenoid
9 Pick-up Motor: Forward
10 Bottom Plate Motor: Reverse
D131/D132/D133
Not Start
Not HP
Not Correct
Position
3-298
Start
HP
Correct Position
SM Appendix