Ricoh D131 Service Manual page 972

Code
15-92 Memory Overflow
15-93 Memory Access Error
15-94 Incorrect ID Code
15-95 Transfer Station Function
22-00 Original length exceeded the
maximum scan length
22-01 Memory overflow while
receiving
22-02 Tx or RX job stalled due to
line disconnection at the other
end
22-04 The machine cannot store
received data in the SAF
22-05 No G3 parameter confirmation
answer
D619
Meaning Suggested Cause/Action

Transmission could not be received
because memory overflowed during the
transaction.

Transaction could not complete due to a
malfunction of SAF memory.

The machine rejected an incoming e-mail
for transfer request, because the ID code
in the incoming e-mail did not match the ID
code registered in the machine.

The machine rejected an incoming e-mail
for transfer because the transfer function
was unavailable.

Divide the original into more than one
page.

Check the resolution used for scanning.
Lower the scan resolution if possible.

Add optional page memory.

Wait for the files in the queue to be sent.

Delete unnecessary files from memory.

Transfer the substitute reception files to an
another fax machine, if the machine's
printer is busy or out of order.

Add an optional SAF memory card or hard
disk.

The job started normally but did not finish
normally; data may or may not have been
received fully.

Restart the machine.

Update the ROM

Replace the FCU.

Defective FCU board or firmware.
80 SM