Grease The Turntable Rotation Bearing And Rotate Gear - Genie S-40 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
2 Loosen the low idle lock nut and turn the low idle
adjustment screw clockwise to increase the
rpm, or counterclockwise to decrease the rpm.
Tighten the low idle lock nut and confirm the
rpm.
a b
a solenoid boot
b high idle adjustment nut
c yoke
d low idle lock nut and adjustment
screw
3 Move the function enable toggle switch to the
high idle (rabbit symbol) position.
Result: High idle should be 2200 rpm.
(before serial no. 7472)
Result: High idle should be 2500 rpm.
(after serial no. 7471)
If high idle rpm is correct, disregard adjustment
step 4.
3 - 16
c d
Genie S-40 and Genie S-45
A-15
Grease the Turntable Rotation
Bearing and Rotate Gear
Genie specifications require that
this procedure be performed every
100 hours of operation. Perform
this procedure more often if dusty
conditions exist.
Frequent application of lubrication to the turntable
bearing and rotate gear is essential to good
machine performance and service life. Continued
use of an improperly greased bearing and gear will
result in component damage.
1 Locate the grease fitting on the front turntable
cover.
2 Pump grease into the turntable rotation bearing.
Rotate the turntable in increments of 4 to 5
inches / 10 to 13 cm at a time and repeat this
step until the entire bearing has been greased.
3 Apply grease to each tooth of the drive gear,
located under the turntable.
Grease type
January 2005
REV A
Multipurpose grease
Part No. 102521