What The Iw Does And Does Not Do - Avaya g700 Installation And Upgrades

What the IW Does and Does Not Do

The IW automates many but not all tasks in an S8300 Media Server installation.
Tasks IW automates
Of the tasks in Chapter 3, Installing a New G700 with an S8300, the IW automates the following:
Installing Communication Manager service pack files, if any
●
Configuring the S8300
●
Note:
See
Note:
Configure the G700 Media Gateway
●
Install new firmware on the G700
●
Note:
In addition, you can use the IW to upgrade media server software or gateway
Note:
firmware on a previously-installed system.
The IW automates similar tasks in Chapters 4–6.
Tasks IW does not automate
You must perform the following tasks manually, even though you are using the IW:
All hardware installation
●
Tasks in Before Going to the Customer Site
●
Any tasks related to adding LSPs to the primary controller you are installing, as
●
documented in
Any tasks related to administration of the primary controller in
●
Manager on page 160
Set Up SNMP Alarming on the G700
●
Using the Avaya Installation Wizard (IW)
Administer Communication Manager
on page 148
on page 130
on page 160:
on page 511, if required
What wizards are available
Administer Communication
Issue 8.1 June 2005 43