Avaya g700 Installation And Upgrades page 614

Upgrade of an existing S8300A to R3.0 with manual upgrade of G700 firmware
At this point, you should not have to enter any configuration information. In the following
procedure, click Continue to open each configuration screen and verify the that configuration
information is correct.
To verify media server configuration
1. Under Server Configuration click Configure Server to start the configure server process.
Click Continue until you reach the screen titled Specify how you want to use this wizard.
Specify how you want to use this wizard screen
2. Select Configure all services using the wizard.
3. Click Continue through all the screens.
Check for new screens and new fields on existing screens as mentioned in the planning
forms.
Note:
You must click Continue through all the screens whether there are changes or
Note:
not. You do not need to enter Static Network Route information.
4. Click Continue on the Update System screen.
The Updating System Files screen displays each configuration task as it completes. When
done, the screen displays the line All configuration information was entered.
5. Click Close Window.
6. Log on to a Telnet session.
7. Type /opt/ws/drestart 1 4 to capture the configuration data.
You should see the response, Killed.
614 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server