Avaya g700 Installation And Upgrades page 533

b. set mgc list <ip_address> [,<ip_address> [,<ip_address>
[,<ip_address>]]]
where, the first <ip_address> is the IP address of the primary controller for this G700.
If the primary controller is an S8700, this is the IP address of a C-LAN board that is
connected to a pair of duplicated S8700/S8710s. If the primary controller is an S8300,
this is the IP address of the S8300.
The next three <ip_address> parameters are optional IP addresses of up to three
alternate controllers. Each of the three optional controllers can be an S8700/S8710
duplicated pair or an S8300 configured as an LSP, depending on the G700's primary
controller.
!
CAUTION:
If you need to change the mgc list, you must run clear mgc list before
CAUTION:
running set mgc list again.
Table 32 describes the possible optional controllers for an S8300 and S8700/S8710 primary
controller:
Table 32: Possible optional controllers for various primary controllers
If primary Then, controller IP addresses can be
controller is
S8300 First: IP address of the S8300 primary controller.
Next three: one, two, or three IP addresses of S8300s configured as LSPs.
S8500 or First: IP address of the C-LAN for the S8500 or S8700/S8710 primary
S8700 or controller.
S8710
Next three: one, two, or three IP addresses of alternate C-LANs and/or
LSPs.
Note:
For an S8500 or S8700/S8710 primary controller, the last three IP addresses in
Note:
the list can be either the addresses of C-LANS (which are connected to the same
S8500 or pair of S8700/S8710s that act as primary controllers) or addresses of
LSPs. If you enter a combination of both, you must list C-LANs first and the LSPs
last, after the C-LANs.
2. Type reset mgp at the MG-???-n(configure)# prompt to reset the G700 media gateway
processor.
A system prompt asks you to confirm the reset.
3. Select Yes at the dialog box that asks if you want to continue.
The G700 media gateway processor resets. The LEDs on the G700 media gateway and the
media modules flash. These elements each conduct a series of self-tests. When the LEDs
on the media modules are extinguished and the active status LEDs on the G700 media
gateway are on, the reset is complete.
Configure the G700
Issue 8.1 June 2005 533