2. Enter the node name for each LSP supported by the primary controller.
3. Submit the form.
Administering the Media Gateway
To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT
session.
!
CAUTION:
Before administering a media gateway, make sure that the gateway has been
CAUTION:
fully configured.
In this section, you will do the procedures:
To add a media gateway
To verify changes
To enable announcements, if necessary
To save Communication Manager translations
To add a media gateway
1. At the SAT prompt, type add media-gateway <number>
where <number> is the gateway number from 1 to n. (n is 50 for an S8300 and 250 for an
S8500 or S8700).
The S8300 displays the Media Gateway screen.
Administer Communication Manager
Issue 8.1 June 2005
173