Administering Network Regions - Avaya g700 Installation And Upgrades

Manual installation of a new G700 without an S8300
Example Node Names Screen
change node-names ip
Name
default_________
node-10-lsp
node-11-lsp
__________
__________
__________
2. Enter the name and IP addresses for the LSPs.
3. Press F3 (Enter) when complete.

Administering Network Regions

Before assigning an IP network region to a G700, you must define network region on the IP
Network Region form. After a network region is defined, you can assign it to the various network
elements (servers, gateways, IP phones).
The information you need to do this should be provided in your planning documentation. Use
the system defaults if the planning documentation does not specify otherwise.
For a G700 with an S8300 as primary controller, there will usually be one network region,
defined as 1. The procedure below uses 1 for the network region number as an example but the
procedure applies for any network region number from 1 to 250.
To define IP network region 1
!
CAUTION:
Defining IP network regions can be quite complex. For detailed information on
CAUTION:
the use and administration of IP network regions, see ''Administration for Network
Connectivity for Avaya Communication Manager, 555-233-504.''
1. At the SAT prompt, type change ip-network-region 1.
The S8300 displays the IP Network Region screen.
546 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
IP NODE NAMES
IP Address
0__.0__.0__.0__ _______________
192.168.1 _.50_ _______________
192.168.1 _.51_ _______________
___.___.___. _ _______________
___.___.___. _ _______________
___.___.___. _ _______________
Name
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
Page 1 of 1
IP Address